Holley Performance Products has written this manual for the installation of the electric choke kit. This manual contains all the information needed to install this system. Please read all the …

This new electronic choke will not solve problems asociated with improperly adjusted carburetors or mal-functionir choke pull-off systems and anti-pollution devices.

The enclosed electric choke kit is designed to replace the existing manual choke on Edelbrock Performer Series carburetors #1405 and #1407. Please fol-low the instructions closely to …

Short term fix: Remove engine service panel and manually move choke. See below: Move choke to the right to close. As the engine starts move the choke left to open. Issue 2: Push button …

Check if the choke has closed fully by placing your finger behind (right side) the link loop, and apply pressure toward the carburetor. The link should not move, which means that the controls …

hoke cap to the housing. When doing so, attach the black ground wire by placing the eyelet end of the wire between the designated cre cho choke housing (Figure 3). Connect the other end of …

To properly set the choke, loosen the choke cap retaining screws and turn the choke cap to the leanest notch on the choke housing. Tighten the choke cap retaining screws, and run the …